|
Zippy Technology R2G-5500V4V,2U Redundant Form,500W,
Input Type Power Factor Correction (PFC), (DxWxH) 276/10.87 (mm/inch)
x 101/3.98 (mm/inch) x 82/3.23 (mm/inch), Module GIN-3500V, Power
Management Bus (PMBUS), High Effenciency Series, Silver 80 Plus power
supply
PRODUCT TECHNICAL
-
500W+500W
-
+3.3v remote sensing
-
As logic level is low, outputs voltage were enable,
as logic level is high, outputs voltage were disable.
-
Current/balance load sharing design
-
Dielectric withstand: input/output 1500 vac for 60
second input to frame ground 1500 vac for 60 second
-
Efficiency: typical >80% at 115vac, 20%~100% max
load
-
Emi noise filter: fcc class b, cispr22 class b
-
Hold up time: 16ms minimum at full load & nominal
input voltage
-
Hot-swappable function
-
Isolation: built-in in power module
-
N+1 redundancy function
-
Over current protection: +3.3v: 27.5~37.5a, +5v: 27.5~37.5a,
+12v: 44~60a
-
Over power protection: 110% ~ 160%
-
Over voltage protection: +5v-5.9v~6.7v, +12v-13.0v~15.0v,
+3.3v-3.9v~4.3v short
-
Power factor correction: active (meet iec-1000-3-2)
-
Power good signal: on delay 100ms to 500ms
-
Remote on/off control
-
Safety: to meet ul, cul, tuv
-
Short circuit protection: +5v, +3.3v, +12v, -12v,
auto-recovered: +5vsb
-
Temperature range: operating 0C~40C, operating temperature:
-20C~80C
-
The power supply shall accept a logic open collector
level which will disable/enable all the output voltage
(exclude +5v standby)
|
